DJI SDR Mounts
Designed to make mounting the DJI SDR to a camera as clean and simple as possible. By utilizing the battery bay of both the camera and the SDR unit has allowed us to create mounts designed for a wide range of cameras and applications.
£35.99
(ex VAT £29.99)
Gear Overview
The 'HaloRC DJI SDR Mount' is designed to make mounting the DJI SDR to a camera as clean and simple as possible. By utilizing the battery bay of both the camera and the SDR unit has allowed us to create mounts designed for a wide range of cameras and applications.
To ensure a a tight fit with very little movement, we developed an anti-wiggle system that uses neoprene pads. This is particularly useful when attaching the camera to a drone where vibrations are a concern.
Each mount is made out of high quality MJF printed nylon. Outlined below is a description of each mount and its intended use case.
LP-E6 Mount
The LP-E6 mount provides a raised mounting point for the SDR TX unit. By raising the SDR slightly allows you to still use you camera on a short style adjustable angle camera mount without the unit getting in the way.
The HDMI port of the Studio G2 and the TX unit are aligned and there is a slot that runs through the mount so that you can route a ribbon style HDMI cable through to connect the two cleanly.
LP-E6 SSD Mount
This version of the LP-E6 mount adds a mounting point for an SSD drive, specifically the same SSD drive used to create our standard LP-E6 SSD mount. Available without the SSD drive or in a 512gb or 1tb version.
This mount also features a cutout for attaching the USB-C cable to cleanly route it to the G2, along with the HDMI ribbon cable slot that runs through the mount.
NP-F (Raised) Mount
The NP-F (Raised) mount is designed to be used for mounting the DJI SDR RX unit to the back of your NP-F battery powered monitor.
This mount provides you with a clean RX and monitor setup, especially when using the slot that runs through the mount and a ribbon style HDMI cable.
Naked BMPCC Sensor Mount
This mount has been designed for the HaloRC NAKED BMPCC V2 4K and 6K-E cameras. The Naked BMPCC Sensor mount attaches to the back of the sensor case and raises the DJI SDR TX unit slightly.
When running your battery in a toilet tank configuration you can still get the camera angle all the way back to the highest angle.
